Details
| We are pleased to introduce our
latest signal integrity tool, the WAVECREST Enhanced Fibre Channel / Gigabit
Ethernet Communications Test Set.
Now you can perform fast and accurate signal integrity and jitter performance measurements
with only the data signals - no bit clock or trigger is required. Consisting of the proven WAVECREST
DTS-2077™ Communication Signal Analyzer, the new AG-100™ Arm Generator, VISI™
6.0 Signal Integrity Software and a system controller, the Test Set will simplify
compliance testing for a variety of network communications boards, devices and systems.
Enhanced Fibre Channel/Gigabit
Ethernet Test Set Features and Benefits include:
- System Measurements- Perform
jitter measurements on RAID, HBA, GBIC, boards and other SAN systems and components.
- Frequency and Protocol Agile-
Jitter Compliance measurements for FC and GBE at 1X and 2X speeds.
- Random and Deterministic Jitter
Separation- Proprietary algorithms separate total jitter into RJ and DJ components.
- BERT equivalent tester-
Determine system and component failure rates in a fraction of the time.
- Multiple input types- System
accepts both differential and single ended inputs and separate amplifiers for low voltage
data signals.
- VISI 6.0™ dataCOM software-
User friendly interface provides extensive jitter diagnostic and analysis tools.
|
|
| Specifications: |
|
|
|
|
|
| DTS-2077™ |
|
|
| Frequency Range |
.04 Hz
to 1.3 GHz |
|
| Maximum Data Rate |
2.5
Gb/s |
|
| Hardware Resolution |
800 fs |
|
| Input Voltage Range |
+/-
1.1V |
|
| Wideband Jitter Noise
Floor |
<3ps
(1) |
|
|
|
|
| (1) Jitter noise floor measured with 200 MHz internal
calibration source |
|
|
|
| AG-100™ |
|
|
| Data Rate Range for
Pattern Match |
1.0625
- 2.5 GB/s |
|
| Pattern Match Length |
1-40
bits |
|
| Programmable Delay
Range |
Up to
78 cycles @ 1x speeds |
|
|
Up to
156 cycles @ 2x speeds |
|
| Programmable Delay
Resolution |
20 ps |
|
| Maximum Data Edge Count |
2(34)
- 1 |
|
| Maximum Input Voltage
Swing at the Balun |
3.8 V
(peak-to-peak) |
|
| Minimum Input Voltage
Swing at the Balun |
200 mV
(peak-to-peak) |
|
| Amplifier Gain |
3.5
Nominal |
|
| Input Impedance |
50
ohms |
|
Wavecrest Corporation, 7275 Bush Lake Road, Edina, MN 55439. Tel: 612-831-0030; Fax: 612-831-4474.
